Mills Hi Top Question

This is the area to talk about everything regarding repairing and restoring machines.

Mills Hi Top Question

Postby RameGoom » Sat Jul 25, 2020 9:03 pm

Quick Help:

I am putting the machine all back together, and can't for the life of me remember where this part goes. I believe it's part of the coin mechanism.

Anyone?

chute.jpg
Slowly building a knowledge base on E2000 series Bally machines and J400 Jennings. Started with the antique Mills and Jennings. Getting there...
User avatar
RameGoom
 
Posts: 354
Joined: Wed Dec 06, 2006 4:47 pm
Location: Loveland, CO

Re: Mills Hi Top Question

Postby tsparts4u » Sat Jul 25, 2020 9:29 pm

It attaches to the right side of the escalator to divert slugs to the slug cup.
tsparts4u
 
Posts: 223
Joined: Fri Mar 02, 2012 6:58 pm
Location: Franklin, WI

Re: Mills Hi Top Question

Postby mechanic » Sun Jul 26, 2020 10:04 am

First the pic is upside down. Flip it so the tab is pointing up. Then it attaches to the front of the escalator on top of the face cover at the lower left . The holes should line up with holes for the cover.
mechanic
 
Posts: 741
Joined: Wed Mar 26, 2014 5:44 pm
Location: Toledo Ohio

Re: Mills Hi Top Question

Postby nhsodaman » Sun Jul 26, 2020 5:41 pm

OIP.jpeg
OIP.jpeg (15.05 KiB) Viewed 3854 times


Hope this helps you can see location
nhsodaman
 
Posts: 21
Joined: Sat Dec 10, 2016 8:38 pm

Re: Mills Hi Top Question

Postby RameGoom » Mon Jul 27, 2020 6:13 pm

Thanks for the pic. I knew it didn't fit on the outside - nothing made sense, but now apart it comes, and will place it where it belongs.

My bad for hurrying to put it together.
Slowly building a knowledge base on E2000 series Bally machines and J400 Jennings. Started with the antique Mills and Jennings. Getting there...
User avatar
RameGoom
 
Posts: 354
Joined: Wed Dec 06, 2006 4:47 pm
Location: Loveland, CO


Return to Repair / Restoration Questions

Who is online

Users browsing this forum: No registered users and 20 guests

cron