CoinOpCollectorForum.com
Forum for those interested in antique coin operated devices
tura bell
Forum rules
This is the spot to list any parts that you are looking for.
This is the spot to list any parts that you are looking for.
4 posts
• Page 1 of 1
Re: tura bell
by nvmos2 » Mon Feb 03, 2014 4:02 pm
If you don't find it here,
you might try the forum at PennyMachines.co.uk
There are probably a lot more guys there with foreign (non-US) machines/parts.
you might try the forum at PennyMachines.co.uk
There are probably a lot more guys there with foreign (non-US) machines/parts.
- nvmos2
- Posts: 889
- Joined: Sat Jan 14, 2012 11:43 am
- Location: SE Virginia
Re: tura bell
by gazza » Tue Feb 04, 2014 11:18 am
Ok thank you for advice and will check them out later.....i thought it was an american machine the mechanism being mills...live and learn i guess
- gazza
- Posts: 2
- Joined: Mon Feb 03, 2014 7:41 am
Re: tura bell
by nvmos2 » Tue Feb 04, 2014 12:22 pm
Yes; Tura was made by a relatively big German coin-op company.
They made a lot of different model machines.
They also revamped American machines, so your slot may very well have a Mills mechanism in it.
Even many of their indigenous bell mechanisms were basically copies of Mills mechanisms, perhaps even licensed by Mills, so parts may be interchangeable.
I would be more careful with the jackpot, however; it may be more unique to a Tura model.
They made a lot of different model machines.
They also revamped American machines, so your slot may very well have a Mills mechanism in it.
Even many of their indigenous bell mechanisms were basically copies of Mills mechanisms, perhaps even licensed by Mills, so parts may be interchangeable.
I would be more careful with the jackpot, however; it may be more unique to a Tura model.
- nvmos2
- Posts: 889
- Joined: Sat Jan 14, 2012 11:43 am
- Location: SE Virginia
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests